STEALTH PARTS

Early Stealth models, particularly 2004 - 2008, were built using Renegade 4x4 parts. We hope this page makes shopping easier for our Stealth customers. However we are unable to get the original steering racks any longer. But WAIT we have found a replacement that will save you over 1/2 the cost of the original.

NEW STEERING RACK

The new steering racks replace the previous ones used on Renegade 4x4 kits and Stealth* The original equipment racks and replacement parts are no longer available. The new steering racks bolt up exactly like the original, but the pinion gear shaft is larger so you must replace the steering rack extension knuckle.

If your steering extension knuckle is welded on instead of being attached by bolt. You will need to cut the old one off and weld the new knuckle on.

STRUT ASSEMBLY

Our struts and strut sub-assemblies are identified by "Imaginative Manufacturing Inc." cast into the aluminum casting. Complete strut assemblies are shipped assembled including cap, spring, shock, bearings, and ball joint.

Struts cast with "Stealth" and Imaginative Manufacturing Inc. do not interchange.

If you have Stealth struts that need to be replaced you will need to purchase

Strut Sub Assembly (includes strut housing, 2 bearings, pinch bots, and retainer plate)
Ball Joint
A-arm

The Imaginative aluminum casting and ball joints do not interchange with Stealth. On some models you will be required to grind the two inner tabs off of the Stealth frame. This is because our A-Arms require 1-12 1/2" bolt where Stealth requires 2 shorter bolts. This does not hurt the integrity of you Stealth frame.